NHTSA lists 2 model-level recall records for this year, make, and model. These records may apply to your vehicle; confirm your specific VIN with NHTSA or the manufacturer.
Recall records
Engine and engine cooling09/19/200606V361000
ON CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH GM 8.1L V8 ENGINES, IMPROPER HARDENING DURING THE HEAT TREATMENT PROCESS CAN CAUSE THE FUEL RAIL PULSE DAMPER RETAINER CLIP TO FRACTURE, RESULTING IN INADEQUATE RETENTION OF THE DAMPER. IF THE DAMPER BECOMES LOOSE, FUEL COULD BE PUMPED BY THE FUEL PUMP INTO THE UNDER HOOD AREA.
Consequence
IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD RESULT.
Remedy
WORKHORSE IS HANDLING THE OWNER NOTIFICATION AND REMEDY FOR THIS CAMPAIGN (PLEASE SEE 06V225). DEALERS WILL REPLACE THE FUEL RAIL PULSE DAMPER RETAINER CLIPS ON THESE ENGINES FREE OF CHARGE. OWNERS MAY CONTACT WORKHORSE AT 877-294-6773 OR MONACO AT 1-800-685-6545.
CUSTOMERS CAN ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION’S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV.
Your record
What is the status for your vehicle?
Check your exact VIN before marking whether this recall applies.
Saved only in this browser. Recall You Later does not receive this information.
ON CERTAIN MOTOR HOMES, AN INCORRECT SCREW WAS USED TO INSTALL THE BLACK AND WHITE CRT BACK-UP MONITOR IN THE DASH. THE INCORRECT SCREWS ARE 1/4" LONGER THAN SPECIFIED AND MAY CONTACT A PC BOARD INSIDE THE MONITOR WHICH COULD POTENTIALLY HIT A HIGH VOLTAGE CIRCUIT ON THE PC BOARD OF APPROXIMATELY 10,000-13,000 VOLTS.
Consequence
IF THE SCREW MAKES CONTACT WITH THE HIGH VOLTAGE TRACER ON THE PC BOARD AND SOMEONE WOULD TOUCH THE SCREW HEAD WHILE THE POWER IS ON, AN ELECTRICAL SHOCK COULD OCCUR CAUSING INJURY.
Remedy
DEALERS WILL INSPECT THE BACK-UP MONITOR TO VERIFY THE OPERATION OF THE MONITOR FREE OF CHARGE. IF THE MONITOR IS OPERATING PROPERLY, THE REPAIR WILL CONSIST OF REPLACING THE INCORRECT SCREW WITH THE SPECIFIED SCREW AND TESTING FOR PROPER OPERATION. IF THE MONITOR IS NOT OPERATING PROPERLY ON INITIAL INSPECTION, THE MONITOR WILL BE REPLACED USING THE CORRECT SCREW. THE RECALL BEGAN ON FEBRUARY 9, 2007. OWNERS MAY CONTACT MONACO AT 877-332-9239.
MONACO RECALL NO. R06040.CUSTOMERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION?S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO HTTP://WWW.SAFERCAR.GOV.
Your record
What is the status for your vehicle?
Check your exact VIN before marking whether this recall applies.
Saved only in this browser. Recall You Later does not receive this information.
